A NODARA tool
Upload an SVG or an image, or try the gear. Relieve estimates grams, meters and cost from the infill, walls and material, and updates as soon as you change anything.
A printed part isn't solid: it has walls, solid top and bottom layers, and infill at a given percentage. Relieve works out each of them from the real shape of your part:
Meters of filament on a 1 kg spool, worked out from each material's density.
| Material | Density | Meters/kg (1.75 mm) | Meters/kg (2.85 mm) |
|---|---|---|---|
| PLA | 1.24 g/cm³ | 335 m | 126 m |
| PETG | 1.27 g/cm³ | 327 m | 123 m |
| ABS | 1.04 g/cm³ | 400 m | 151 m |
| ASA | 1.07 g/cm³ | 389 m | 146 m |
| TPU | 1.21 g/cm³ | 344 m | 130 m |
Example: an 80 × 80 × 5 mm plate in PLA, two walls and four top and bottom layers.
| Infill | Typical use | Approx. weight |
|---|---|---|
| 10% | Decorative parts | ≈ 16 g |
| 20% | General use | ≈ 19 g |
| 50% | Load-bearing parts | ≈ 27 g |
| 100% | Maximum strength | ≈ 40 g |
Multiply the grams by your spool's price per kilogram and divide by 1,000. Relieve does it for you: enter the price in the Print menu.
About 335 meters at 1.75 mm and about 126 meters at 2.85 mm.
15–20% is typical. Go up to 40–50% for load-bearing parts and down to 10% for decorative ones.
Because the slicer also counts the skirt, supports and its specific infill pattern. Relieve gives an estimate so you can decide before slicing.
Yes. In the Print menu you can set walls, line width, layer height, top and bottom layers, filament diameter and price.